E700 Barcode scanner

First, we need to set the terminal settings for Barcode. Go to Back Office > Setup > Terminals > Choose the terminal > Bar Code Reader > Reader Type and Format to need to be blank. 

On the settings for the PT assign to the E700 it needs to have enabled either Scan Front or Scan Rear.

On the FOH, the customer needs to Login > On the order screen > Hit Barcode > Scan

​

• Related Articles

• Ordyx Network Configuration

    Ordyx Network configuration In order for terminals to communicate effectively, the proper network setup has to be implemented. All network devices (computers, printers, handhelds, etc…) must be on the same network. This is essential for the sharing ...

• How to configure the Scanner on Ipad

  If the customer wants to use the scanner for barcodes on Ipad You must install the Ipad as a Terminal, it doesn't work as a HH, once you configure it as a terminal go to the store setting, the bar code reader tab should be blank. Open Ordyx and you ...

• Dejavoo Setup and configuration

  DejaVoo EMV Setup Follow the steps below to set up a Dejavoo Emv. 1. When configuring a Dejavoo terminal the first thing you should do is remote into the terminal, and ask the customer which IP address to use and the DHCP range if the customer does ...

• Alerts Setup

  Alerts Ordyx enable users to receive notifications via email or text to keep them informed on what is going on in the store with out being on site. To setup alerts you will need to: 1. Find your profile under the staff list and scroll to the section ...

• POSBank A10 Network/WiFi Setup

  The following steps will help you configure a POSBank A10 to work with Ordyx. 1. Start by having the customer connect the printer to the network on which Ordyx is located. This must be via ethernet cable. 2. Have the customer power on and reset the ...